FIA, manufacturers open ‘constructive dialogue’ on F1 engine rules

For 2026, the power unit will comprise a 1.6 litre V6 turbocharged internal combustion engine with a significantly enhanced electrical component. The MGU-H will be removed. The electrical power output will increase substantially with a more powerful MGU-K and larger energy store.

Any PU Manufacturer intending to supply a Power Unit to an F1 Team during a Championship (year N) must: a. Declare to the FIA, before 1 August of year N-1, that they provided to their customer F1 Teams: i. An initial full external space model of the Power Unit including details and locations of all physical interfaces required by the team to install the Power Unit. ii. Preliminary estimates of important operating parameters such as heat rejection, fuel mass and density, clutch shaft stiffness and engine stiffness. b. Declare to the FIA, before 1 November of year N-1, that they provided to their customer F1 Teams: i. A final full external space model of the Power Unit including details and locations of all physical interfaces required by the team to install the Power Unit. ii. Firm predictions of important operating parameters such as heat rejection, fuel mass and density, clutch shaft stiffness and engine stiffness. iii. Initial details of any other parts, procedures, operating conditions and limits or any other information required by the team to install and operate the Power Unit as intended. After the 1 August of year N-1, any significant change compared to previous communication, must be notified to the customer F1 Teams in due time. Should a Customer Team consider that the change has an unreasonable impact on the Power Unit installation in the car, they may contact the FIA within 7 days of the notification. The FIA will then contact the relevant PU Manufacturer and its customer F1 Teams in order to conduct its investigation. If the FIA is satisfied, in its absolute discretion, that these changes are acceptable, the FIA will confirm to the PU Manufacturer and the customer F1 Teams within 14 days that they may be carried out.

Any PU Manufacturer registered must submit to FIA a Power Unit homologation dossier before 1 March of first year intending to supply. Each PU Manufacturer shall present only one homologation dossier.