Floor Corner

In Simple Terms

This rule allows teams to add special corner bodywork at the floor edges that doesn't have to follow normal floor restrictions. However, this corner piece must fit within a defined boundary zone and can only have a limited number of sections or layers in different directions—up to 3 sections going front-to-back, 4 sections going side-to-side, and 2 sections going up-and-down.

• Floor corner bodywork gets an exemption from standard floor rules but must stay within the RV-FLOOR-CORNER boundary
• Maximum complexity is 3 sections in the X-direction (front-to-back), 4 in the Y-direction (side-to-side), and 2 in the Z-direction (up-and-down)
• This controlled flexibility allows aerodynamic optimization at the floor corners while preventing unrestricted complexity