Article C3.11.1
Rear Wing Profiles
Technical Regulations
Article C3.11.1
Rear Wing Profiles
Chapter: C3
In Simple Terms
The rear wing must fit within a specific design area and can have up to three separate sections. It cannot have inward-curving surfaces visible from underneath, and any inward curves visible from above must have a minimum radius of 100mm to ensure safety and fair aerodynamic performance.
- Rear wing bodywork must stay within the defined RV-RW-PROFILES design box
- Maximum of three non-overlapping sections allowed in the rear wing structure
- No concave (inward-curving) surfaces allowed when viewed from below
- Any concave surfaces visible from above must have at least 100mm radius to prevent sharp curves
Official FIA Text
Rear Wing Profiles Bodywork must lie in its entirety within RV-RW-PROFILES, comprise of up to three non-intersecting simply connected volumes, and contain no concave radius of curvature visible from below and no concave radius less than 100mm visible from above.
rear wingbodywork profileconcave radiusaerodynamic bodyworkwing design
2026 Season Regulations